Re-emergence of a GII.4 Norovirus Sydney 2012 Variant Equipped with GII.P16 RdRp and Its Predominance over Novel Variants of GII.17 in South Korea in 2016

Noroviruses are major causative pathogen of nonbacterial acute gastroenteritis worldwide. Of the seven genogroups of noroviruses suggested recently, genogroup II genotype 4 (GII.4) had been the most common genotype identified in hospitalized patients in the last few decades. However, since the latter half of 2014, new variants of GII.17 have been reported as the main causes of outbreaks over GII.4 in East Asia and have also occurred in America and Europe. In this study, we monitored norovirus GII in coastal streams at South Gyeongsang province and South Jeolla province of South Korea from March 2015 to May 2016. Norovirus GII.17 capsid sequences were predominantly detected until September 2015 in water samples. However, we found that the number of positive cases of the norovirus GII.4 Sydney 2012 capsid sequence has been increasing since December 2015, overtaking that of GII.17 in 2016. The RdRp genotype of this predominant GII.4 variant in 2016 was identified as GII.P16. The emergence and predominance of the GII.4 pandemic capsid sequence harboring a different RdRp genotype suggested the potential for a future pandemic.     

Effects of varying dilutions, pH, temperature and cations on spermatozoa motility in fish Larimichthys polyactis

The objectives of this present study were to assess the effects of varying dilutions, pH, temperature and cations on spermatozoa motile parameters (SMPs) in fish Larimichthys polyactis. Optimal SMPs were observed when emen was diluted in artificial seawater (ASW) at a ratio of 1 to 100, with temperature of 10 degreesC and pH 8.0. The spermatozoa of L. polyactis were immotile in distilled water and motile in solution containing different cations. Maximum SMPs were obtained in each solution containing 0.4 mol NaCI, 0.4 mol KCI, 0.2 mol CaCI2 and 0.2 mol MgCl2. This study provides baseline knowledge of L. polyactis spermatozoa sensitivity of pH, temperature and cationic effects.     

Screening of Cucumis sativus as a new arsenic-accumulating plant and its arsenic accumulation in hydroponic culture

Phytoextraction is a remediation technology with a promising application for removing arsenic (As) from soils and waters. Several plant species were evaluated for their As accumulation capacity in hydroponic culture amended with As. Cucumis sativus (cucumber) displayed the highest tolerance against As among 4 plants tested in this study (corn, wheat, sorghum and cucumber). The germination ratio of Cucumis sativus was more than 50% at the high concentration of 5,000 mg-As/l. In Cucumis sativus grown in a solution contaminated with 25 mg-As/l, the accumulated As concentrations in the shoot and root were 675.5 ± 11.5 and 312.0 ± 163.4 mg/kg, respectively, and the corresponding values of the translocation and bioaccumulation factors for As were 1.9 ± 0.9 and 21.1 ± 8.4, respectively. These results indicate Cucumis sativus is to be a candidate plant for phytoextraction of As from soils and water.     

Occurrence of disinfection by-products in tap water distribution systems and their associated health risk

The concentrations of trihalomethanes (THMs), including chloroform, bromodichloromethane, dibromochloromethane, and bromoform, and haloacetic acids (HAAs; monochloroacetic acid, monobromoacetic acid, dibromoacetic acid, dichloroacetic acid, and trichloroacetic acid) were measured in tap waters passing through water distribution systems of six water treatment plants in Seoul, Korea, and their associated health risks from exposure to THMs through ingestion, dermal contact, and inhalation were estimated using a probabilistic approach. The concentration ranges for total THMs and HAA₅ were 3.9–53.5 and <LOD–49.5 μg/L, respectively. Among DBPs, chloroform, bromodichloromethane, dichloroacetic acid, and trichloroacetic acid were the most frequently detected. Spatial and seasonal variations in concentrations of THMs and HAAs in the six water distribution systems were significant (P?<?0.001).The mean lifetime cancer risks through ingestion, dermal contact, and inhalation during showering ranged as 7.23–10.06?×?10^?6, 2.19–3.63?×?10^?6, and 5.22–7.35?×?10^?5, respectively. The major exposure route to THMs was inhalation during showering. Sensitivity analysis showed that shower time and shower frequency had a great impact on the lifetime cancer risk by the exposure to THMs in tap water.     

THE COSTS OF CONFLICTING ENVIRONMENTAL POLICY: A CASE STUDY IN MILWAUKEE1

ABSTRACT: The history of the Milwaukee water pollution abatement program is examined as a case study to investigate the costs of conflicting environmental policy. The recent U.S. Supreme Court decision concerning the Milwaukee case is described as a milestone in U.S. water pollution abatement policy which will help preclude the type of environmental policy conflict which has been found to be so costly to Milwaukee. The implications to U.S. water pollution abatement policy of the 13-year history of conflict in Milwaukee are presented.     

Mineralogical characteristics and transformations during long-term operation of a zerovalent iron reactive barrier

Design and operation of Fe0 permeable reactive barriers (PRBs) can be improved by understanding the long-term mineralogical transformations that occur within PRBs. Changes in mineral precipitates, cementation, and corrosion of Fe0 filings within an in situ pilot-scale PRB were examined after the first 30 months of operation and compared with results of a previous study of the PRB conducted 15 months earlier using X-ray diffraction and scanning electron microscopy employing energy dispersive X-ray and backscatter electron analyses. Iron (oxy)hydroxides, aragonite, and maghemite and/or magnetite occurred throughout the cores collected 30 mo after installation. Goethite, lepidocrocite, mackinawite, aragonite, calcite, and siderite were associated with oxidized and cemented areas, while green rusts were detected in more reduced zones. Basic differences from our last detailed investigation include (i) mackinawite crystallized from amorphous FeS, (ii) aragonite transformed into calcite, (iii) akaganeite transformed to goethite and lepidocrocite, (iv) iron (oxy)hydroxides and calcium and iron carbonate minerals increased, (v) cementation was greater in the more recent study, and (vi) oxidation, corrosion, and disintegration of Fe0 filings were greater, especially in cemented areas, in the more recent study. If the degree of corrosion and cementation that was observed from 15 to 30 mo after installation continues, certain portions of the PRB (i.e., up-gradient entrance of the ground water to the Fe0 section of the PRB) may last less than five more years, thus reducing the effectiveness of the PRB to mitigate contaminants.     

Determination of the required surface area of a final clarifier for an activated-sludge system.

A generic methodology for determining the required surface area of a final clarifier is presented. Clarification and thickening requirements are integrated to form a unified procedure for final clarifier design. The new method is based on results obtained by Yuen (2002) on the solids flux theory for a secondary clarifier; it does not require the specification of recycle rate, which is computed as an output of the method. The author shows that there is a minimum required surface area (A(m)) for a final clarifier under the thickening requirement when the designed recycle rate is set at the maximum allowable value (FR)m (at the critical state). The designed surface area and the return activated sludge pumping capacity can be determined by applying a safety factor to A(m) and (FR)m, respectively. The method is shown to conform to conventional design criteria under typical design conditions.     

Quantitative characterization of recyclable resources dismantled from waste liquid crystal display products

Currently only limited materials, such as common metals and plastics, are recovered from waste flat-panel displays, thus necessitating the development of a comprehensive recycling process. This study aims to establish a statistical database about the types and amounts of valuable resources in waste liquid crystal display (LCD) products. To obtain these data, the waste LCD products were disassembled into four components: plastics, printed circuit boards, metals, and other materials, including their panels, and the weight of each component was measured. Overall, the product weight decreased with increasing manufacturing year regardless of the product screen size; however, the decreasing rate varied from 14 to 73%. The metal weight ratios decreased significantly by 24–31%. Meanwhile, regardless of the manufacturing year, the plastic weight ratios remained almost constant at about 20%. On the other hand, the weight ratio of the other components increased by 26–46% with increasing manufacturing year suggesting that rare-earth metal recycling has become more important. These statistical analyses are expected to contribute to the development of an eco-friendly, high-efficiency dismantling/separation process that will enable higher value recycling and minimal waste disposal.     

Thermoeconomic installation limit of PV/WT hybrid energy systems for Off-grid islands

An ideal off-grid island can become 100% energy-sufficient if one installs renewable energy systems such as solar photovoltaic (PV) and wind turbine (WT) systems. However, the intermittent and uncertain nature of the power supply from renewable energy systems hinders a 100% autonomy level (AL) without an infinite energy storage capacity. The thermoeconomic installation limit (TEIL) of a PV/WT hybrid energy system was studied using hourly weather data and the energy demand profile for off-grid islands. An appropriate battery size for the TEIL was also determined. Given the current installation cost of the hybrid energy system and the battery unit, the AL for a PV/WT hybrid energy system at the TEIL is calculated to be approximately 70%. Above the limit, the size of the energy storage unit and, correspondingly, the total annual cost of the PV/WT hybrid energy system increase sharply.     

Temporal variation of volatile organic compounds and their major emission sources in Seoul, Korea

This study examines the characteristics of volatile organic compounds (VOCs) and their major emission sources at the Bulgwang site in Seoul, Korea. The annual levels of VOCs (96.2–121.1 ppb C) have shown a decreasing trend from 2004 to 2008. The most abundant component in Seoul was toluene, which accounted for over 23.5 % of the total VOCs on the parts per billion on a carbon basis, and the portions of alkanes with two to six carbons constituted the largest major lumped group, ranging from 40.1 to 48.4 % (45.3?±?3.7 %) of the total VOCs. Major components of the solvent (toluene, m/p-xylene, o-xylene, and ethylbenzene) showed high in daytime and summer and low in nighttime and winter due mainly to the variation of the ambient temperature. The species mostly emitted from gasoline vapor (i/n-butane, i/n-pentane, n-hexane, and 2-methylpentane) and vehicular exhaust (ethylene, acetylene, and benzene) showed bimodal peaks in the diurnal variation around the commuting hours because of the high traffic volume. For the 14 out of 15 highest concentration species, the weekend effect was only evident on Sundays because of the stepwise implementation of the 5-day work-week system. Principal components analysis (PCA) was applied in order to identify the sources of the 15 highest concentration VOCs and, as a result, three principal components such as gasoline vapor (48.9 %), vehicular exhaust (17.9 %), and evaporation of solvents (9.8 %) were obtained to explain a total of 76.6 % of the data variance. Most influential contributing sources at the sampling site were traffic-related ones although the use of solvent was the dominant emission source based on the official emission inventory.